Use the lift correctly

1. Before use, turn on the power supply, check whether the motor power supply is installed correctly, and check whether the hoist has leakage and oil leakage.

2. Park the vehicle in the middle of the lift, which can support the lift arm at the designated support position of the vehicle chassis.

3. Put the car into P or N gear and pull the handbrake.

4. Align the four support points (on the designated position of the car chassis), which are usually strengthened by steel plates and can bear large forces

5. Lift the vehicle in three steps

Start the lift step by step and stop lifting the vehicle when the fulcrum approaches the vehicle. Check whether the fulcrum is aligned with the vehicle.

The second step is to start the lift. After the fulcrum contacts the vehicle, recheck the position of the fulcrum, and lift the vehicle 300 mm above the ground after confirmation

The third step is to push the vehicle on the side of the vehicle, and lift the vehicle to the working height after confirming that the vehicle is stable.

6. When lowering the vehicle, first remove the insurance, and then slowly lower the vehicle!